*The DM1 will not work with condenser microphones, or other phantom powered microphones. If necessary, a cable can be used between the microphone and the DM1 - but the shorter the cable, the better the overall performance will be. Reliable operation even in demanding on-stage applications in difficult environments is ensured by the roadworthy and slim all-metal design, robust construction, and high-quality manufacturing standards.įor optimum results, we recommend you plug the DM1 directly into your microphone’s output. The DM1 is an active inline preamp intended to be inserted between a passive ribbon or dynamic microphone and a microphone preamplifier.
#Se electronics dm1 manual
Its output impendence is also the lowest in its class, allowing it to drive long cable runs while reducing susceptibility to RF interference, buzz and hum. sE Electronics DM1 User Manual Thank you We would like to thank you cordially for choosing this sE DM1 We hope you enjoy using it as much as we enjoyed designing and building it for you. The DM1 is the perfect way to boost the signal from a passive mic, reduce the likelihood of interference, and provide significantly improved level to your preamp – all without adding noise or coloration. Additionally, the gain it provides is always a consistent 28dB regardless of the connected load, thanks to its dedicated buffer amplifier. With a sophisticated class-A design and specially-selected high-grade FETs, the DM1 has vastly lower output impedance and nearly half the noise of anything else on the market. The DM1 DYNAMITE is an ultra-slim active inline preamp that fits seamlessly between your mic and mic pre, providing a massive +28dB of clean, transparent gain for all your dynamic and passive ribbon microphones. The sE Electronics DM1 is an active inline preamp intended to be inserted between a passive ribbon or dynamic microphone and a microphone preamplifier. Some mics need a LOT of gain - and not all preamps are up to the challenge. Engage the +48V phantom power circuit on your preamp.Plug the XLR microphone cable into the DM1 sE Electronics DM1 Dynamite Plug the DM1 directly into your passive microphone Plug the XLR microphone cable into the DM1 Engage the +48V phantom power.Plug the DM1 directly into your passive microphone.The DM1 DYNAMITE: explosive level for all your passive mics.
0 kommentar(er)
